Market...Submitted by Flip on Sat, 01/07/2012 - 12:37
Will do...Submitted by Dylano on Sat, 01/07/2012 - 12:56
In reply to Market... by Flip
Try to see if you can get a 2Submitted by Badger on Sat, 01/07/2012 - 13:35
The plastic wastes are goodSubmitted by Fillide on Sat, 01/07/2012 - 14:25
In reply to Try to see if you can get a 2 by Badger
I have used lengths of plastic plumbing waste (probably 38mm diam) to reach high beams as Badger suggests. The trick is to buy the brush end bit first, (you should be able to find something with close to a 90deg angle already on it) and then select or arrange your wastepipe to fit. Often a Hoover bit will fit inside the spigot end, sometimes the pipe will fit inside the brush bit. For lightness you might want to use the white cheapo waste pipe, but the heavier red pipe is usefully rigid and comes in longer lengths.
Try this - wont cost you aSubmitted by Esme on Sat, 01/07/2012 - 14:03
Try this - wont cost you a penny - it's what I do with my beams here in the UK - even though they aren't quite 6 metres high and it works. Get a ball of twine - chuck it over the beam - hold onto the "open" end - tie the end of the twine to one corner of a decent duster or cloth and another to the other corner of the cloth and use one to pull/lift the cloth onto the beam. You can then pull the cloth back and forth along the beam to clean it by using both lengths. Hope that makes sense.
Esme, your method would workSubmitted by Dylano on Sat, 01/07/2012 - 14:29
In reply to Try this - wont cost you a by Esme